Trigger Subsystem; Trigger Subsystem Command Reference - Agilent Technologies N9360A Programming Manual

TRIGger Subsystem

TRIGger Subsystem Command Reference

N9360A Multi UE Tester GSM Programming Manual
The TRIGger commands are used to control a measurement
cycle.
Abort
TRIGger:ABORt
This command aborts measurement and resets the trigger
system, and the trigger sequence state returns to idle.
Trigger Immediately
TRIGger:IMMediate
This command immediately starts a measurement. When
measurement is completed, the Tester's state becomes idle.
Trigger Mode
TRIGger:MODE SINGle|CONTinuous
TRIGger:MODE?
This command selects the trigger mode to either a single or
continuous (repetitive) measurement. The parameter is SINGle
or CONTinuous. At preset, this is set to SING.
This query command returns the selected trigger mode with
string.
Programming Command Reference
5
5-197