Agilent Technologies N9360A Programming Manual page 192

Programming Command Reference
5
N O T E
N O T E
5-134
The step in execution is set to 1, and the others are set to 0. The
value in the parentheses is decimal value for each bit. Refer to
Setting and Querying the Registers
• <int 2> contains total results of the measurement. The
returned value is 0 (Test result available: only passed items),
1 (Test result available: including failed items) or 2 (None).
If the mode is set to GSM, this command is invalid.
TESTs:MANual:SIGNaling:STATe:EXPand?
This query command returns test content and system type
currently being executed with integer value of <int 1> and <
int 2>. Each value is separated by a comma.
• <int 1> contains test contents currently being executed in
GPRS/EGPRS mode. The following 7-bit values are returned.
bit 0 (1): Attach
bit 1 (2): Attached
bit 2 (4): Connected
bit 3 (8): Timeout Error
bit 4 (16): NA
bit 5 (32): NA
bit 6 (64): Processing ...
The step in execution is set to 1, and the others are set to 0. The
value in the parentheses is in decimal value for each bit. Refer
to Setting and Querying the Registers
• <int 2> contains the system currently being executed. The
return value is 1 (W-CDMA), 0 (GSM) or 2 (CDMA2000).
If the mode is set to GSM, this command is invalid.
on page 4-18.
on page
N9360A Multi UE Tester GSM Programming Manual
4-18.