Agilent Technologies N9360A Programming Manual page 144

Programming Command Reference
5
5-86
Default Gateway
CONFigure:NETwork:DEFault:GATEway <enum>,<string
DEFAULTGATEWAY>
CONFigure:NETwork:DEFault:GATEway?
This command displays the address being set in the
DEFAULTGATEWAY on the screen.
<enum> is used to enable or disable the Default Gateway
address. ACT enables and NONE disables the setting.
Specify in the DEFAULTGATEWAY the address to be displayed on
the screen.
If NONE is specified for <enum>, setting in the
DEFAULTGATEWAY is unnecessary.
Executing this command does not reflect the result on the
tester, yet.
The result is reflected on the tester as
CONFigure:NETwork:APPLy:ADDRess is implemented.
Query of this command obtains the address of the Default
Gateway being set. If NONE is selected for the Default Gateway
address, the value of <enum> alone is returned.
Gateway
CONFigure:NETwork:GATEway:SET1
<enum1>,<string1>,<enum2>,<string2>
CONFigure:NETwork:GATEway:SET1?
CONFigure:NETwork:GATEway:SET2
<enum1>,<string1>,<enum2>,<string2>
CONFigure:NETwork:GATEway:SET2?
CONFigure:NETwork:GATEway:SET3
<enum1>,<string1>,<enum2>,<string2>
CONFigure:NETwork:GATEway:SET3?
N9360A Multi UE Tester GSM Programming Manual