Figure 3-3 Typical Setup For Automated Test System (Gp-Ib Interface) - Agilent Technologies N9360A Programming Manual

Preparing for Use
3

Figure 3-3 Typical Setup for Automated Test System (GP-IB Interface)

3-4
Using an Option E02
The following equipment is required to configure an automated
test system using the GP-IB interface:
• The Agilent N9360A Multi UE Tester (with option E02).
• A USB-GPIB Converter (option E02).
• A system controller with the GP-IB interface.
• An IEEE-488 (GP-IB) cable
• An RF cable to connect RF signal from/to the mobile phone
under test, the Antenna Coupler (Agilent N9360A-A02) to
connect RF signal from/to the mobile phone, or the Shield
case (Agilent N9360A-S01) to couple RF signal from/to the
mobile phone.
• A printer and an appropriate cable (if required)
A typical setup for an automated test system using the GP-IB
interface looks like the illustration in Figure 3-3
N9360A Multi UE Tester GSM Programming Manual
below: