Agilent Technologies N9360A Programming Manual page 194

Programming Command Reference
5
N O T E
N O T E
5-136
Modulation and Coding Scheme (EGPRS mode)
TESTs:MANual:CSCHeme:Egprs
MCS1|MCS2|MCS3|MCS4|MCS5|MCS6|MCS7|MCS8|MCS9|
TESTs:MANual:CSCHeme:Egprs?
This command sets EGPRS Coding Scheme. The allowable range
is MSC1 to MSC9. At preset, this is set to MCS5.
If the mode is set to GSM or GPRS, this command is invalid.
Signaling Result (GSM mode)
TESTs:MANual:RESults:SIGNaling?
This query command returns the test results value <int>.
• <int> is sum of the value of 7 bits as follows.
bit 0 (1): Location Update
bit 1 (2): MS Call
bit 2 (4): MS Release
bit 3 (8): BS Call
bit 4 (16): BS Release
bit 5 (32): Connection
bit 6 (64): Handover
Each bit is set to 0 if the test is pass, or each bit is set to 1 if the
test is fail. The value in the parentheses is decimal value for
each bit. Refer to Setting and Querying the Registers
page 4-18.
If there are no test results, all bits are set to 1 and the value 511
is returned.
When the GPRS/EGPRS mode is currently set, the number of bits used
and meaning each bit are not the same as the other modes.
N9360A Multi UE Tester GSM Programming Manual
on