Command Reference For Network Setting Screen - Agilent Technologies N9360A Programming Manual

Programming Command Reference
5

Command Reference for Network Setting Screen

The Network Setting command is used to implement the setting
required establish connection with Ethernet.
Apply Address
CONFigure:NETwork:APPLy:ADDRess
This command reflects the settings done from the screen with
the following commands (Network Setting) on the tester system.
CONFigure:NETwork:IPaddress
CONFigure:NETwork:DEFault:GATEway
CONFigure:NETwork:GATEway:SET1-SET5
IP Address
CONFigure:NETwork:IPaddress <string
IPADDRESS>,<int>
CONFigure:NETwork:IPaddress?
This command displays the address being specified for the
IPADDRESS on the screen.
<int> specifies the subnet mask address.
A value in CIDR format is entered to <int>.
Effective setting range for the IPADDRSS is 1.0.0.1 to
223.255.255.255 and the subnet mask address (in CIDR format)
is 1 to 31.
Executing this command does not reflect the result on the
tester, yet.?
The result is reflected on the tester as
CONFigure:NETwork:APPLy:ADDRess is implemented.
Query of this command obtains the IP Address and subnet mask
address (a value in CIDR format).
N9360A Multi UE Tester GSM Programming Manual 5-85