Overview Of The Gp-Ib Interface; Table 4-2 Gp-Ib Configuration - Agilent Technologies N9360A Programming Manual

Programming Command Guideline
4

Overview of the GP-IB Interface

Table 4-2 GP-IB Configuration

Item
GP-IB Address:
EOI
Terminator:
4-8
Settings for the GP-IB Interface
Refer to the documentation on your controller, programming
language, and I/O interface card to configure the GP-IB
interface.
The GP-IB configuration is not programmable but manually set
using the User Interface. The preset settings and allowable
range are as follows:
Preset
2
On
CR+LF
The terminator outputted from the Tester can be changed as
specified in Table
The terminator inputted to tester is LF (for GPIB option E02)
The terminator inputted to tester is CR+LF (for GPIB option
E00
If EOI is set to , the terminator is not transmitted.
On
Refer to the following procedure to set the GP-IB configuration.
Allowable Range
1 to 15
On, Off
CR+LF, CR, LF
4-2.
N9360A Multi UE Tester GSM Programming Manual