Table of Contents
Advertisement
Commands in DSR Application Subsystems
Return Value
134
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[:CGRoup(*)][:SOURce]:TRIGger
Subsystem
:<Handle>[:CGRoup(*)][:SOURce]:TRIGger
This command subsystem is used to set the trigger or strobe output
parameters.
:<Handle>[:CGRoup(*)][:SOURce]:TRIGger:
DELay
Syntax
:<Handle>[:CGRoup(*)][:SOURce]:TRIGger:DELay <NRf>
The delay of the trigger output signal can be varied with this
command. For frequencies <= 330 MHz in the range of 0 to 360 ns, for
frequencies >330 MHz in the range of 0 to 3.3 ns
Example
:_test:CGR1:TRIG:DEL 2e-9
:<Handle>[:CGRoup(*)][:SOURce]:TRIGger:
DELay?
Syntax
:<Handle>[:CGRoup(*)][:SOURce]:TRIGger:DELay?
Returns the current delay of the trigger output signal.
Example
:_test:CGR1:TRIG:DEL?
might return:
2.000000E-009
Agilent 81250 Parallel Bit Error Ratio Tester, Programming Reference, March 2006
[:CGRoup(*)][:SOURce]:TRIGger Subsystem
Advertisement
Table of Contents
