Programming Command Guideline
4
Overview of the RS-232C Serial Interface
Table 4-3 Serial Port Configuration
Item
Baud Rate:
Data Length:
Stop bits:
Parity:
Xcontrol:
Terminator:
4-10
Settings for the Serial Interface
Refer to the documentation on your controller, programming
language, and an I/O interface card to configure the serial
interface.
The serial port configuration is not programmable but manually
set using the User Interface. The preset settings and allowable
range are as follows:
Preset
9600
8
1
None
None
CR+LF
The terminator outputted from the Tester can be change as
specified in
Table
The terminator inputted to tester is LF (for GPIB option E02)
The terminator inputted to tester is CR+LF (for GPIB option
E00
Refer to the following procedure to set the serial port
configuration.
Other Choices
9600, 19200, 38400, 57600, 115200
7, 8
1, 1.5, 2
None, Odd, Even
None, Xon/Xoff
CR, LF, CR+LF
4-3.
N9360A Multi UE Tester GSM Programming Manual