Configure Subsystem; Configure Subsystem Command Reference - Agilent Technologies N9360A Programming Manual

Programming Command Reference
5

CONFigure Subsystem

CONFigure Subsystem Command Reference

5-32
This subsystem sets or queries the controls and parameters on
the [Configuration] screen.
Beeper Control
CONFigure:BEEPer ON|OFF|1|0
CONFigure:BEEPer?
This command sets the beeper function to ON (1) or OFF (0). If
this is set to ON, there is beep for each step of operation. If this
is set to OFF, beep is suppressed except for some errors and
warnings. At preset, this is set to 1.
This query command returns the beep setting with integer value
of 1 or 0.
10MHz Reference Oscillator
CONFigure:ROSCillator?
This query command returns the reference signal setting with
string of INT or EXT.
Date
CONFigure:DATE <int YYYY>,<int MM>,<int DD>
CONFigure:DATE?
This command sets the default of the calendar in the Tester.
<int YYYY> is year within the range from 1990 to 2037, <int
MM> is month within the range from 1 to 12 and <int DD> is
day within the range from 1 to 31.
This query command returns the date of the calendar in the
Tester by <int YYYY>, <int MM> and <int DD>. The range of
these values is same as that of the command parameter.
N9360A Multi UE Tester GSM Programming Manual