Overview Of The Ethernet Interface; Table 4-1 Ethernet Configuration - Agilent Technologies N9360A Programming Manual

Overview of the Ethernet Interface

Table 4-1 Ethernet configuration

Item
IP Addr
CIDR (Mask)
Gateway
Addr
Terminator
N9360A Multi UE Tester GSM Programming Manual
Settings for the Ethernet Interface
Refer to the documentation on your controller, programming
language, and a LAN card to configure the Ethernet interface.
The Ethernet configuration is not programmable but manually
set using the User Interface. The preset settings and allowable
range are as follows:
Preset
192.168.0.1
24(255.255.255.0)
NONE
0.0.0.0
CR+LF
The terminator outputted from the Tester can be changed as
specified in Table
The terminator inputted to the Tester is LF (fixed).
The TCP port number is 10123 (fixed).
User cannot use the address from 192.168.1.1 to 192.168.1.255
as it is already used by the Tester.
Refer to the following procedure to set the Ethernet
configuration.
Programming Command Guideline
Allowable Range
1.0.0.1 to 223.255.255.255
1 to 31
NONE, ACT
1.0.0.1 to 223.255.255.255
CR+LF, CR, LF
4-1.
4
4-5