Agilent Technologies N9360A Programming Manual page 108

Programming Command Reference
5
5-50
RX Quality Test
CONFigure:SEQuence:QUALity <int>
CONFigure:SEQuence:QUALity?
This command sets whether to execute the RX Quality test in
the test sequence on the six measurement channels. <int> sets
whether to execute this test on each Traffic Channel by the total
sum of the 6 bits as follows.
bit 0 (1): Testing on the TCH1
bit 1 (2): Testing on the TCH2
bit 2 (4): Testing on the TCH3
bit 3 (8): Testing on the TCH4
bit 4 (16): Testing on the TCH5
bit 5 (32): Testing on the TCH6
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the Registers
The set of each bit is 1 for Run and 0 for — (skip). At preset, this
is set to 63.
This query command returns the set of RX Quality test with
integer. The meaning of the return value is same as that of the
command parameter.
on page
N9360A Multi UE Tester GSM Programming Manual
4-18.