Programming Command Summary
6
Configuration: Test Condition (Loss) Screen
Table 6-8 CONDition (Loss) Command Summary
Item
Attenuation Control
Configuration: Test Condition (Limit) Screen
Table 6-9 CONDition (Limit) Command Summary
Item
Power Control Level
Peak TX Power Limit
Burst Timing Limit
Phase Error Limit
Frequency Error Limit
6-16
The following commands are used to set the controls and
parameters associated with the [Configuration: Test Condition
(Loss)] screen.
Command
CONF:LOSS ON|OFF|1|0
CONF:LOSS?
CONF:LOSS:RFIN <<
<real 1>,<real 2>,<real 3>,<real 4>,
CONF:LOSS:RFIN?
CONF:LOSS:RFOU <<
<real 1>,<real 2>,<real 3>,<real 4>,
CONF:LOSS:RFOU?
The following commands are used to set the controls and
parameters associated with the [Configuration: Test Condition
(Limit)] screen
Command
CONF:COND:LIM:TXP:PLEV <int>
CONF:COND:LIM:TXP:PLEV?
CONF:COND:LIM:TXP <<
<int PLEV>,<real LO>,<real HI>
CONF:COND:LIM:TXP?
CONF:COND:LIM:BTIM <real LO>,<real HI>
CONF:COND:LIM:BTIM?
CONF:COND:LIM:PHAS:RMS <real HI>
CONF:COND:LIM:PHAS:RMS?
CONF:COND:LIM:PHAS:PEAK <real HI>
CONF:COND:LIM:PHAS:PEAK?
CONF:COND:LIM:FREQ <int LO>,<int HI>
CONF:COND:LIM:FREQ?
N9360A Multi UE Tester GSM Programming Manual