Connecting To Controller; Ethernet; Gp-Ib - Agilent Technologies N9360A Programming Manual

Preparing for Use
3

Connecting to Controller

Ethernet

GP-IB

RS-232C
N O T E
3-6
An Ethernet connector is provided with the Tester as the
Ethernet interface to connect a controller.
• If your controller (PC) has an Ethernet interface, use the
UTP (10BASE-T/100BASE-TX) cross-over cable to connect
the controller (PC) and the Tester directly. Or, use two
straight cables and a HUB to connect the controller and the
Tester.
The tester is equipped with the IEEE-488 (GP-IB) connector
(option E00), or a USB-GPIB converter (Option E02) is proviced
for the Tester as a GP-IB interface to connect the controller.
• If your controller (PC) has an IEEE-488 (GP-IB) connector,
use an IEEE-488 (GP-IB) cable to connect the the controller
and the Tester with the Option E00. Or, use the USB-GPIB
converter (option E02) and an IEEE-488 (GP-IB) cable to
connect the controller (PC) and the Tester.
A DB-9 male connector (option E01) is provided with the Tester
as the serial interface to a controller.
If your controller (PC) has a serial interface, refer the following
explanations.
• If your controller (PC) has a DB-9 male connector, use the
9-pin female to 9-pin female RS-232C null modem cable to
connect the controller (PC) and the Tester.
• If your controller (PC) has a DB-25 male connector, insert
the 9-pin male to 25-pin female adapter between the 9-pin
female RS-232C null modem cable and the 25-pin male
connector to connect the controller (PC) and the Tester.
Ignore the control lines (CTS, DSR, DCD and RI) status with the controller.
N9360A Multi UE Tester GSM Programming Manual