Agilent Technologies N9360A Programming Manual page 152

Programming Command Reference
5
5-94
This command sets the test result of the Talk test step to pass or
fail. The parameter is PASS or FAIL.
Signaling State
TESTs:AUTO:MEASure:SIGNaling:STATe?
This query command returns the test step currently executed in
a test cycle. The return value contains the currently executed
status of 9 bits as follows.
bit 0 (1): Location Update
bit 1 (2): 1st Call
bit 2 (4): Talk
bit 3 (8): RF Test
bit 4 (16): 1st Release
bit 5 (32): 2nd Call
bit 6 (64): 2nd Release
bit 7 (128): Measurement end with test result
bit 8 (256): Measurement end without test result (Aborted or
Time out error occurred)
The executed step is set to 1, and the others are set to 0.
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the Registers
TESTs:AUTO:MEASure:SIGNaling:STATe:EXPand?
This query command returns the test contents currently being
executed and system type with integer value contained <int
1> and < int 2>. Each value is separated by a comma.
<int 1> contains test contents currently being executed. The
return value of 12 bits are as follows:
bit 0 (1): Location Update
bit 1 (2): 1st Call
bit 2 (4): Talk
bit 3 (8): 1st Release
bit 4 (16): 2nd Call
on page
N9360A Multi UE Tester GSM Programming Manual
4-18.