Agilent Technologies N9360A Programming Manual page 309

Table 7-4 Program Comments
Line Description
29: Displays message to an operator: Talk.
30-34: Request input of Talk test result to an operator. Depending on the input result, send a test result from the PC
to the Tester.
35: Displays message to an operator: Measuring!
36: Waits until the 1st Release is completed.
37: Displays message to an operator: Please MS Release.
38: Waits until the MS Release is completed.
39: Displays message to an operator: Please off hook.
41: Waits until the measurement is completed.
44: Declare variable to store channel number for the measurement result display.
45: (-61:) Repeats to get test results for three channels.
46: Queries the channel number.
47: Displays the channel number on the status field.
48: Queries the measurement result of Peak TX Power.
49: Displays the measurement value and Pass or Fail result of Peak TX Power (High) on the status field.
50: Displays the measurement value and Pass or Fail result of Peak TX Power (Mid) on the status field.
51: Displays the measurement value and Pass or Fail result of Peak TX Power (Low) on the status field.
52: Queries the measurement result of Burst Timing.
53: Displays the measurement value and Pass or Fail result of Burst Timing on the status field.
54: Queries the measurement result of Power Ramp.
55: Displays the measurement value and Pass or Fail result of Power Ramp on the status field.
56: Queries the measurement result of Phase Error.
57: Displays the measurement value and Pass or Fail result of Phase Error RMS on the status field.
58: Displays the measurement value and Pass or Fail result of Phase Error Peak on the status field.
59: Queries the measurement result of Frequency Error.
60: Displays the measurement value and Pass or Fail result of Frequency Error on the status field.
63: Displays the [Automatic Test : Stand-by] screen.
64: Displays Complete message on the status field.
N9360A Multi UE Tester GSM Programming Manual
Sample Program
7
7-9