Agilent Technologies N9360A Programming Manual page 184

Programming Command Reference
5
N O T E
5-126
BER/FER/BLER Test
TESTs:MANual:SENSitivity:STATe ON|OFF|1|0
TESTs:MANual:SENSitivity:STATe?
This command sets whether or not to execute the error rate
Sensitivity (BER, FER, Fast BER, BLER and SRB Loopback
BER) test. The parameter is ON (1) or OFF (0). At preset, this is
set to 1.
This query command returns the set of the error rate Sensitivity
(BER, FER, Fast BER, BLER and RB Loopback BER) test with
integer value of 1 or 0. The meaning of the return value is same
as that of the command parameter.
Test Loop mode should be set before executing this command.
Averaging
TESTs:MANual:AVERage OFF|2-200
TESTs:MANual:AVERage?
This command sets whether to activate the averaging. The
parameter is OFF or <int> for the number of averaging times.
The allowable range of <int> is from 2 to 200. At preset, this is
set to OFF.
This query command returns the set averaging.
RF Signal Output Mode
TESTs:MANual:RFOUtput ON|OFF|1|0
TESTs:MANual:RFOUtput?
This command sets the RF Output mode. The parameter is ON
(1) or OFF (0). At preset, this is set to 1.
N9360A Multi UE Tester GSM Programming Manual