Agilent Technologies N9360A Programming Manual page 48

Programming Command Guideline
4
4-14
Step 3
Configure test setting on the [Configuration] screen.
< Send Command to the Tester> CONF:LOSS ON
< Send Command to the Tester> CONF:LOSS:RFIN
0.5,0.5,0.5,0.5
< Send Command to the Tester> CONF:LOSS:RFOU
1.0,1.0,1.0,1.0
Step 4
Configure test setting on a test mode screen. For example, the
Manual Test mode test sets as follows:
< Send Command to the Tester> TEST:MAN:RFOR DCS1800
Step 5
Create an instruction message as follows for the operator to
turn on the mobile phone and wait for the Location Update to
complete.
<Display Message on the PC screen> Turn on the mobile phone
and wait to finish the Location Update. Then press OK.
<Wait until the OK button on the PC screen is clicked on>
Step 6
Start the BS Call, and then check that the test flow changes to
the Talk/RF Test step.
< Send Command to the Tester> TEST:MAN:BSC
<Send Query Command to the Tester> TEST:MAN:SIGN:STAT?
If the Response is not
Else, proceed to the next step.
Step 7
Start the measurement.
<Send Command to the Tester> TRIG:IMM
, re send the query.
2
N9360A Multi UE Tester GSM Programming Manual