Agilent Technologies N9360A Programming Manual page 312

Sample Program
7
Table 7-5 Program Comments
Line Description
7: Queries the manufacturer, model number, serial number and revision number of the firmware.
8-11: Displays the manufacturer, model number, serial number and revision number of the firmware on the status field.
14: Resets the Tester to the default setting for programming.
15: Activates the Loss correction function.
16: Sets the Loss RF IN value.
17: Sets the Loss RF OUT value.
20: Selects the Radio System to DCS1800.
21: Waits until the [Manual Test : Stand-by] screen is displayed on the Tester.
22: Displays message to an operator: Turn on the mobile phone.
23: Waits until the signaling state changes to Location Update.
24: Displays message to an operator: Wait until [Location Update] is passed.
25: Wait until Location Update is passed.
26: Executes the BS Call.
27: Waits until the signaling state changes to talk/RF Test (connection).
30: Displays the [Peak TX Power/Burst Timing/Power Ramp] screen on the Tester.
31: Starts the Peak TX Power measurement.
32: Waits until the measurement is completed.
33: Queries the measurement result of Peak TX Power.
34: Displays the measurement value and Pass or Fail result of Peak TX Power on the status field.
37: Displays the [Phase Error/Frequency Error] screen on the Tester.
38: Starts the Phase Error/Frequency Error measurement.
39: Waits until the measurement is completed.
40: Queries the measurement result of Phase Error.
41: Displays the measurement value and Pass or Fail result of Phase Error RMS on the status field.
42: Displays the measurement value and Pass or Fail result of Phase Error Peak on the status field.
43: Queries the measurement result of Frequency Error.
44: Displays the measurement value and Pass or Fail result of Frequency Error on the status field.
46: Executes the BS Release.
49: Displays Complete message on the status field.
7-12 N9360A Multi UE Tester GSM Programming Manual