Agilent Technologies N9360A Programming Manual page 115

Programming Command Reference
5
Release Delay
CONFigure:SEQuence:RELeasedelay <int>
CONFigure:SEQuence:RELeasedelay?
This command sets the delay time after release. The allowable
range is from 0 to 9. At preset, this is set to 5.
This query command returns the set of delay time after release
with integer. The range of the value is same as that of the
command parameter.
RF Signal Output Mode
CONFigure:SEQuence:RFOUtput AUTO|ON
CONFigure:SEQuence:RFOUtput?
This command sets the RF Output in Automatic Test. The
parameter is AUTO or ON. At preset, this is set to ON.
This query command returns the set of RF Output with strings
of AUTO or ON.
3GPP system
CONFigure:SEQuence:3GPPsystem <int>
CONFigure:SEQuence:3GPPsystem?
This command sets the 3GPP system. The allowable range is
from 1 to 5 with step size of 1. At preset, this is set to 2. This
command works when the Sequence Number 1 is selected.
The query command returns sets 3GPP System with integer. The
range of the value is the same as that of the command
parameter.
N9360A Multi UE Tester GSM Programming Manual 5-57