Agilent Technologies N9360A Programming Manual page 165

N9360A Multi UE Tester GSM Programming Manual
Power Ramp Flatness
TESTs:AUTO:RESults:RAMP1:FLATness?
TESTs:AUTO:RESults:RAMP2:FLATness?
TESTs:AUTO:RESults:RAMP3:FLATness?
TESTs:AUTO:RESults:RAMP4:FLATness?
TESTs:AUTO:RESults:RAMP5:FLATness?
TESTs:AUTO:RESults:RAMP6:FLATness?
This query command returns the maximum value and the
minimum value in the burst on section in the Power Ramp.
• <int1> is the test result for the 0 (pass) or 1 (fail).
• <real2> is the maximum value (dB). If measurement result
is out of range or measurement result is not measured, the
value -99.99 is returned.
• <real3> is the minimum value (dB). If measurement result
is out of range or measurement result is not measured, the
value -99.99 is returned.
Power Ramp Trace Start
TESTs:AUTO:RESults:RAMP1:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP1:TRACe:STARt?
TESTs:AUTO:RESults:RAMP2:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP2:TRACe:STARt?
TESTs:AUTO:RESults:RAMP3:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP3:TRACe:STARt?
TESTs:AUTO:RESults:RAMP4:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP4:TRACe:STARt?
TESTs:AUTO:RESults:RAMP5:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP5:TRACe:STARt?
TESTs:AUTO:RESults:RAMP6:TRACe:STARt <real>
TESTs:AUTO:RESults:RAMP6:TRACe:STARt?
This command sets the start point of trace data in Power Ramp
for the query command.
Programming Command Reference
5
5-107