Agilent Technologies N9360A Programming Manual page 215

N O T E
N9360A Multi UE Tester GSM Programming Manual
BER Measurement
GSM mode, Test Loop C
TESTs:MANual:RESults:SENSitivity:BERFast?
GPRS mode, Test Mode B
TESTs:MANual:RESults:SENSitivity:BERGprs?
EGPRS mode, Test Mode SRB
TESTs:MANual:RESults:SENSitivity:SRB?
This query command returns the Sensitivity measurement
result values <int 1>, <int 2> and <real 3>. Each value is
separated by a comma.
• <int 1> (1 digit) is 0 if measurement results are within the
measurement range, or 1 if any measurement result is out of
range or the BER is not measured.
• <int 2> (1digit) is the test result for the 0 (pass) or 1 (fail).
• <real 3> is the measured result of the BER data ranging
from 0.00 to 100.00 in %. If measurement result is out of
range or the BER is not measured, the value 99.99 is
returned.
The above commands are valid only for corresponding mode setting.
Sensitivity Test Frames
GSM Mode, Test Loop A
TESTs:MANual:SENSitivity:FRAMe <int>
TESTs:MANual:SENSitivity:FRAMe?
GSM Mode, Test Loop C
TESTs:MANual:SENSitivity:FRAMe:BERFast <int>
TESTs:MANual:SENSitivity:FRAMe:BERFast?
Programming Command Reference
5
5-157