Agilent Technologies N9360A Programming Manual page 129

Programming Command Reference
5
Frequency Error Limit
CONFigure:CONDition:LIMit:FREQuency <int
LO>,<int HI>
CONFigure:CONDition:LIMit:FREQuency?
This command sets the low and high limits for Frequency Error
tests for each radio system set by the Radio System command
described on page 5-34. The allowable range is from -99999 to
99999 Hz in 1 step. At preset, these are set to -90 and 90 Hz for
GSM850 and GSM900, -171 and 171 Hz for DCS1800, and -185
and 185 Hz for PCS1900, respectively.
This query command returns the set low and high limits for
Frequency Error test with integer separated by a comma. The
range is same as that of the command parameter.
If the GSM mode is set to GPRS or EGPRS in Manual Test mode,
N O T E
measurement cannot be executed.
RX Quality Limit
CONFigure:CONDition:LIMit:QUALity <int LO>,<int
HI>
CONFigure:CONDition:LIMit:QUALity?
This command sets the low and high limits for RX Quality test.
The parameter is 0 (<0.2), 1 (0.2 to 0.4), ......, 6 (6.4 to 12.8), or 7
(>12.8 %). At preset, these are set to 0 and 4.
This query command returns the set low and high limits for RX
Quality test with integer separated by a comma. The range is
same as that of the command parameter.
RX Level Limit
CONFigure:CONDition:LIMit:LEVel <int LO>,<int
HI>
CONFigure:CONDition:LIMit:LEVel?
This command sets the low and high limits for RX Level tests for
each radio system set by the Radio System command described
on page 5-34. The parameters and the preset values are shown
in the following tables:
N9360A Multi UE Tester GSM Programming Manual 5-71