N O T E
N9360A Multi UE Tester GSM Programming Manual
Signaling State (GPRS/EGPRS mode)
TESTs:MANual:SIGNaling:STATe?
This query command returns the test step currently executed in
a test cycle for the GPRS/EGPRS mode. The return value
contains the status in execution of 7 bits as follows.
bit 0 (1): Idle or End
bit 1 (2): Attached
bit 2 (4): Connected
bit 3 (8): Timeout Error
bit 4 (16): NA
bit 5 (32): NA
bit 6 (64): Busy
The step in execution is set to 1, and the others are set to 0. The
value in the parentheses is decimal value for each bit. Refer to
Setting and Querying the Registers
When the GSM mode is currently set, the number of bits used and
meaning each bit are not the same as the other modes.
TESTs:MANual:SIGNaling:STATe:EXTension?
This query command returns test content and result currently
being executed with integer value of <int 1> and < int 2>.
Each value is separated by a comma.
• <int 1> contains test contents currently being executed in
GPRS/EGPRS mode. The following 7-bit values are returned.
bit 0 (1): Idle or End
bit 1 (2): Attached
bit 2 (4): Connected
bit 3 (8): Timeout Error
bit 4 (16): NA
bit 5 (32): NA
bit 6 (64): Busy
Programming Command Reference
on
page
4-18.
5
5-133