Agilent Technologies N9360A Programming Manual page 125

N O T E
N O T E
N9360A Multi UE Tester GSM Programming Manual
Incremental Redundancy
CONFigure:CONDition:INCRementalredundancy
ON|OFF|1|0
CONFigure:CONDition:INCRementalredundancy
This command sets the Incremental Redundancy. The
parameter is ON (1) or OFF (0). At preset, this is set to 0.
This command is valid when the mode is set to EGPRS mode.
EVM Measure Count
CONFigure:CONDition:EVMMeascount <int>
CONFigure:CONDition:EVMMeascount?
This command sets EVM Meas. Count for EGPRS mode. The
allowable range is from 1 to 200. At preset, this is set to 1.
This command is valid when the mode is set to EGPRS mode.
Location Update Delay
CONFigure:CONDition:LOCupdatedelay <int>
CONFigure:CONDition:LOCupdatedelay?
This command sets the delay time after completion of location
update. The allowable range is from 0 to 9. At preset, this is set
to 0.
This query command returns the set location update delay with
integer. The range of the value is same as that of the command
parameter.
Programming Command Reference
5
5-67