Trigger Subsystem; Trigger Subsystem Command Reference - Agilent Technologies N9360A Programming Manual

5
Programming Command Reference

Trigger Subsystem

Trigger Subsystem Command Reference

5-78
Menu Screen
SYSTem:RBT
This command returns to the [Top Menu] Screen.
The Trigger commands are used to control a measurement cycle.
Trigger Immediately
TRIGger:IMMediate
This command immediately starts a measurement. When
measurement is completed, the Tester's state becomes idle.
Trigger Mode
TRIGger:MODE SINGle|CONTinuous
TRIGger:MODE?
This command sets the trigger mode to either a single or
continuous (repetitive) measurement. The parameter is
or . At preset, this is set to
CONTinuous
This query command returns the selected trigger mode with
string.
Abort
TRIGger:ABORt
This command aborts measurement and resets the trigger
system, and the trigger sequence state returns to idle.
N9360A Multi UE Tester W-CDMA Programming Manual
SINGle
.
SINGle