Agilent Technologies N9360A Programming Manual page 229

Programming Command Reference
5
RF Signal Output Mode
TXANalyzer:RFOUtput ON|OFF|1|0
TXANalyzer:RFOUtput?
This command sets a mode of RF Output. The parameter is ON
(1) or OFF (0). At preset, this is set to 0.
EVM Meas. Count
TXANalyzer:EVMMeascount <int>
TXANalyzer:EVMMeascount?
This command sets the value of EVM Meas. Count. The
parameter is ranging from 1 to 200. At preset, this is set to 1.
This command is valid when Demodulation is set to 8-PSK. Installation of
N O T E
the Option G03 is required.
Change System
TXANalyzer:SYSTem GSM|WCDMA|CDMA2000
TXANalyzer:SYSTem?
This command causes switching to the specified system (GSM,
W-CDMA and CDMA2000). It is enabled in the standby status.
Query of this command obtains the specified system in the
character string.
N9360A Multi UE Tester GSM Programming Manual 5-171