Agilent Technologies N9360A Programming Manual page 71

Programming Command Reference
5
Default Gateway Address
CONFigure:NETwork:DEFault:GATEway
<enum>,<string>
CONFigure:NETwork:DEFault:GATEway?
This command sets the default gateway address. <enum> sets
whether or not to enable the default gateway address. The
parameter is ACT (for enabling) or NONE (for disabling). When
<enum> is set to ACT, the default gateway address can be set
with <string>, ranging from 1.0.0.1 to 223.255.255.255. But,
from 192.168.1.1 to 192.168.1.1255 are unavailable to use the IP
address because the Tester uses them internally.
This query command returns ACT and the setting of default
gateway address when <enum> is set to ACT. This returns NONE
only when <enum> is set to NONE.
Setting 1 to 5 Gateway Address
CONFigure:NETwork:GATEway:SET1 <enum 1>,<string
1>,<enum 2>,<string 2>
CONFigure:NETwork:GATEway:SET1?
CONFigure:NETwork:GATEway:SET2 <enum 1>,<string
1>,<enum 2>,<string 2>
CONFigure:NETwork:GATEway:SET2?
CONFigure:NETwork:GATEway:SET3 <enum 1>,<string
1>,<enum 2>,<string 2>
CONFigure:NETwork:GATEway:SET3?
CONFigure:NETwork:GATEway:SET4 <enum 1>,<string
1>,<enum 2>,<string 2>
CONFigure:NETwork:GATEway:SET4?
CONFigure:NETwork:GATEway:SET5 <enum 1>,<string
1>,<enum 2>,<string 2>
CONFigure:NETwork:GATEway:SET5?
These commands set the gateway addresses for Setting 1 to
Setting 5. <enum 1> sets whether or not to enable the gateway
address for Setting 1 to Setting 5. The parameter is ACT (for
enabling) or NONE (for disabling). <string 1> specifies the
Host/Net address. When <enum 2> is set to NONE, <string 1>
N9360A Multi UE Tester GSM Programming Manual 5-13