Gp-Ib; Figure 3-2 Typical Setup For Automated Test System (Gp-Ib Interface) - Agilent Technologies N9360A Programming Manual

GP-IB

Figure 3-2 Typical Setup for Automated Test System (GP-IB Interface)

N9360A Multi UE Tester GSM Programming Manual
Using an Option E00
The following equipment are required to configure an
automated test system using the GP-IB:
• The Agilent N9360A Multi UE Tester (with option E00).
• A system controller with the GP-IB interface.
• An IEEE-488 (GP-IB) cable.
• An RF cable to connect the RF signal from or to the mobile
phone under test, the Antenna Coupler (Agilent
N9360A-A02) to connect the RF signal from or to the mobile
phone to couple the RF signal from or to the mobile phone.
• A printer and an appropriate cable (if required).
A typical setup for an automated test system using the GP-IB as
shown in Figure 3-2 below:
Preparing for Use
3
3-3