Agilent Technologies N9360A Programming Manual page 145

Programming Command Reference
5
CONFigure:NETwork:GATEway:SET4
<enum1>,<string1>,<enum2>,<string2>
CONFigure:NETwork:GATEway:SET4 ?
CONFigure:NETwork:GATEway:SET5
<enum1>,<string1>,<enum2>,<string2>
CONFigure:NETwork:GATEway:SET5?
This command sets the Gateway Address of Setting1 - Setting5.
<enum1> is used to enable or disable the Gateway address.
<String1> specifies the Host/Net address. If NONE is specified
for <enum2>, the address is treated as the Host-specifying
address and it functions as the Gateway for the communication
directed to one of the Hosts.
If NONE is specified for <enum2>, the address is treated as the
Host-specifying address and functions as the Gateway for the
communication directed to one of the Hosts. <enum2> is used to
select which of the Host and Net is to be specified and also used
to specify the subnet mask value of the specified subnet when
the Net is specified.
When NONE is selected, the address of <string1> is treated as
the Host address. If any value other than NONE is specified, the
subnet mask value of the <string1> address is specified. The
value of <enum2> is represented in the CIDR format and
selectable in the range 1 to 31. <string2> specifies the
Gateway address.
Executing this command does not reflect the result on the
tester, yet.
The result is reflected on the tester as
CONFigure:NETwork:APPLy:ADDRess is implemented.
Following lists the effective setting range.
N9360A Multi UE Tester GSM Programming Manual 5-87