Agilent Technologies N9360A Programming Manual page 315

Table 7-6 Program Comments
Line Description
2: Declares the variable to store test results.
4: Erases the status field.
7: Queries the manufacturer, model number, serial number and revision number of the firmware.
8-11: Displays the manufacturer, model number, serial number and revision number of the firmware on the status field.
14: Resets the Tester to the default setting for programming.
15: Activates the Loss correction function.
16: Sets the Loss RF IN value.
17: Sets the Loss RF OUT value.
18: Sets the GSM Mode to GPRS.
21: Sets the Radio System to DCS1800.
22: Waits until the [Manual Test : Stand-by] screen is displayed on the Tester.
24: Displays message to an operator: Turn on the mobile phone.
25: Waits until Attach is completed.
26: Displays Attached in the status field.
29: Displays the [Peak TX Power/Burst Timing/Power Ramp] screen.
30: Starts the Peak TX Power measurement.
31: Waits until the measurement is completed.
32: Queries the measurement result of Peak TX Power.
33: Displays the measurement value and Pass or Fail result of Peak TX Power on the status field.
36: Displays the [Phase Error/Frequency Error] screen on the Tester.
37: Starts the Phase Error/Frequency Error measurement.
38: Waits until the measurement is completed.
39: Queries the measurement result of Phase Error.
40: Displays the measurement value and Pass or Fail result of Phase Error RMS on the status field.
41: Displays the measurement value and Pass or Fail result of Phase Error Peak on the status field.
42: Queries the measurement result of Frequency Error.
43: Displays the measurement value and Pass or Fail result of Frequency Error on the status field.
46: Executes the BS Release.
48: Displays Complete message on the status field.
N9360A Multi UE Tester GSM Programming Manual
Sample Program
7
7-15