Configuration Screen
System Configuration Screen
Table 6-5 CONFigure Subsystem Command Summary
Item
Beeper Control
10 MHz Reference Oscillator
Date
Time
Panel Key Control
Printer Control
Log Save
N9360A Multi UE Tester GSM Programming Manual
The following commands are used to set the controls and
parameters associated with the basic system requirement, file
management, test condition, and test sequence screens.
The following commands are used to set the reference signal
oscillator source, date and time, beeper, RF attenuation,
firmware update, and so forth which are fundamentally
required to operate the Tester.
Command
CONF:BEEP ON|OFF|1|0
CONF:BEEP?
CONF:ROSC?
CONF:DATE <int YYYY>,<int MM>,<int DD>
CONF:DATE?
CONF:TIME <int HH>,<int MM>
CONF:TIME?
CONF:PKEY UNLOCK|LOCK
CONF:PKEY?
CONF:PRIN PMG800|USBMemory
CONF:PRIN?
CONF:LOG:DEBUG:SAVE
Programming Command Summary
6
6-7