Agilent Technologies N9360A Programming Manual page 82

Programming Command Reference
5
5-24
• When the [Automatic Test : Stand-by] screen is currently
displayed, the Sequence number, 1 or 2, is returned.
[Automatic Test: Burst Timing/Power Ramp]?[Automatic
Test: Peak TX Power]?[Automatic Test: Phase
Error/Frequency Error] or [Automatic Test: Sensitivity/RX
Quality/RX Level] screen is currently displayed, the number
of TCH, a number from 1 until 6, is returned. When the other
screen is displayed, 0 is returned.
Initial Screen
DISPlay:INIT
This command selects the [Initial] screen.
Display fast mode
DISPlay:MODE FAST|TRACk
DISPlay:MODE?
This command sets the display mode. FAST is fast mode, TRACk
is normal mode. It cannot set up during testing of Automatic
Test, signaling and mesurement state of Manual Test, and
measurement state of Tx Analyzer. If FAST mode is specified,
since renewal of a screen is not performed, it usually operates
earlier than normal mode. In order to cancel FAST mode, it is
canceled by send TRACk by this command or pressing the soft
key [Local]. At preset, this is set to TRACk.
This query command returns the display mode (FAST or
TRACk) setting with strings.
N9360A Multi UE Tester GSM Programming Manual