Agilent Technologies N9360A Programming Manual page 49

N9360A Multi UE Tester GSM Programming Manual
Step 8
To read the measurement results, wait until the measurement
ends.
<Send Query Command to the Tester> *STB?
If the Response is not
Else, proceed to the next step.
Step 9
Read the Peak TX Power test results, for example:
<Send Query Command to the Tester> TEST:MAN:RES:TXP?
<Display Message on the PC> Peak TX Power :<Value 3> dBm
<Display Message on the PC>
If the <Value 2> is not 0, Message is FAIL.
Else, Message is PASS.
Step 10
Start the BS Release, for example:
<Send Command to the Tester> TEST:MAN:BSR
<Send Query Command to the Tester> TEST:MAN:SIGN:STAT?
If the Response is not
Else, complete the test.
Programming Command Guideline
, re send the query.
0
, re send the query.
16
4
4-15