Agilent Technologies N9360A Programming Manual page 160

Programming Command Reference
5
5-102
These commands activate the zooming function on the Power
Ramp graph screen for each of the six measurement channels.
The parameter is ON (1) or OFF (0). If the parameter is set to ON,
the rising and trailing edges are expanded. At preset, these are
set to 0.
These query commands return the selected zooming function on
the Power Ramp graph screen with integer value of 1 or 0. The
meaning of the return value is same as that of the command
parameter.
Power Ramp Marker Measurement
TESTs:AUTO:RESults:RAMP1:MARKer?
TESTs:AUTO:RESults:RAMP2:MARKer?
TESTs:AUTO:RESults:RAMP3:MARKer?
TESTs:AUTO:RESults:RAMP4:MARKer?
TESTs:AUTO:RESults:RAMP5:MARKer?
TESTs:AUTO:RESults:RAMP6:MARKer?
These query commands return values at marker position on the
Power Ramp graph screen with values <int 1>, <int 2>,
<real 3> and <real 4> for each of the six measurement
channels. Each value is separated by comma.
• <int 1> (1 digit) is 0 if measurement result is within the
measurement range, or 1 if any value is out of range or the
Power Ramp is not measured.
• <int 2> (1 digit) is the test result for the 0 (pass) or 1 (fail).
• <real 3> (up to 7 letters) is the marker position ranging
from -9.25 to 156.25 (bits) when the zoom function is set
to off, or from -8.00 to 2.00 (bits) and 145.00 to 155.00
(bits) when the zoom function is set to on.
• <real 4> (up to 5 letters) is the measured power level at the
marker position.
N9360A Multi UE Tester GSM Programming Manual