Agilent Technologies N9360A Programming Manual page 201

N O T E
N9360A Multi UE Tester GSM Programming Manual
Each bit is set to 0 if the test is pass, or each bit is set to 1 if the
test is fail. The value in the parentheses is decimal value for
each bit. Refer to Setting and Querying the Registers
page 4-18.
• <real 3> (up to 4 letters) and <real 4> (up to 4 letters)
are the measured rms and peak error data ranging from 0.0
to 99.9 in ° (degrees). If any measurement result is out of
measurement range or the Phase Error is not measured, the
value 99.9 is returned.
This command is invalid when Modulation and Coding Scheme is set to
MCS5 to MCS9 in EGPRS mode.
Frequency Error Measurement
TESTs:MANual:RESults:FREQuency?
This query command returns the Frequency Error
measurement result values <int 1>, <int 2> and <int 3>.
Each value is separated by a comma.
• <int 1> (1 digit) is 0 if measurement result is within the
measurement range, or 1 if measurement result is out of
range or the Frequency Error is not measured.
• <int 2> (1 digit) is the test result for the 0 (pass) or 1 (fail).
• <int 3> (up to 6 letters) is the measured Frequency Error
data ranging from -99999 to 99999 in Hz. If measurement
result is out of measurement range or the Frequency Error is
not measured, the value 99999 is returned.
This command is a command for compatibility with the former,
and returns measured value by the resolution of a 1Hz unit.
Since a following EXPand command can return in finer
resolution, and it is recommendation to use it.
TESTs:MANual:RESults:FREQuency:EXPand?
This query command returns the Frequency Error
measurement result values <int 1>, <int 2> and <int 3>.
Each value is separated by a comma.
• <int 1> (1 digit) is 0 if measurement result is within the
measurement range, or 1 if measurement result is out of
range or the Frequency Error is not measured.
• <int 2> (1 digit) is the test result for the 0 (pass) or 1 (fail).
Programming Command Reference
on
5
5-143