Table of Contents
Advertisement
Discovering Devices
Note
Run CDP Discovery
Note
Run CDP Discovery Now
Step 1
Step 2
Step 3
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
6-8
Chapter 6
Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Import devices from a file or from a CiscoWorks server—See
•
page
6-11.
If WDS is configured on the subnet, CDP discovery proceeds automatically via
WLCCP for the infrastructure access points. The access points must be properly
configured. All access points will be used as seeds. The WDS must also be
configured and in the managed state. For device configuration information, see
Chapter 5, "Setting Up Devices—CiscoWorks 1105/1130/1130-19."
Before discovery can proceed, you must specify at least one initiating IP address
(seed device), from which other devices can be discovered. Neighbors of the seed
device are discovered according to the CDP distance that you specify. The seed
device and discovered devices must be CDP-enabled.
By default, the WLSE runs a CDP discovery every 24 hours.
Use the procedures in this section to run an immediate or scheduled discovery:
Run an immediate, one-time CDP discovery—See
•
page
6-8.
Modify the default CDP discovery schedule by scheduling a one-time job or
•
repeated jobs—See
To run an immediate discovery, perform the following steps:
Select Devices > Discover > DISCOVER > Discovery Wizard.
Select Automatic Device Discovery based on Cisco Discovery Protocol, and
click Next.
Select Run Now and click Next.
Modify the CDP Discovery Schedule, page
Import Devices,
Run CDP Discovery Now,
6-10.
78-16345-01
Advertisement
Table of Contents
