Ipv6 Pim-Sm Commands; Ipv6 Pimsm Bsr-Border; Ipv6 Pimsm Bsr-Candidate - NETGEAR GSM7228PS Cli Manual

10.1.37.2 0/24
--------- -------

IPv6 PIM-SM Commands

This section describes the PIM-SM commands you use to configure Protocol Independent
Multicast - Sparse Mode (PIM-SM) in IPv6.

ipv6 pimsm bsr-border

Use this command to prevent bootstrap router (BSR) messages from being sent or received
through an interface.
Default disabled
Format
ipv6 pimsm bsr-border
Mode Interface Config
no ipv6 pimsm bsr-border
Use this command to disable the interface from being the BSR border.
Format
no ipv6 pimsm bsr-border
Mode Interface Config

ipv6 pimsm bsr-candidate

This command is used to configure the router to announce its candidacy as a bootstrap router
(BSR).
Default None
Format
ipv6 pimsm bsr-candidate interface <unit/slot/port> [hash-mask-
length] [priority]
Mode Global Config
IPv6 Multicast Commands
1 30
--------- -------
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
6-8