3. Fields and parameters are as described in
Editing FCIP circuits
FCIP circuit settings may be edited from the Edit FCIP Circuit dialog box. The procedure for
launching this dialog box for the 4 Gbps Extension Switch and Blade is different than the procedure
for the 8 Gbps Extension Switch and the 8 Gbps Extension Blade. Also note the following
differences for these platforms:
•
•
For the 4 Gbps Extension Switch and Blade:
1. From the FCIP Tunnels dialog box, select the tunnel you want to edit.
2. Select Edit.
3. Select Edit to the right of the Circuits properties table at the bottom of the dialog box.
Document Title
xx-xxxxxxx-01
FIGURE 299
Edit FCIP Tunnel dialog box
editable fields and parameters.
The 4 Gbps Extension Switch and Blade have only one circuit per tunnel, and the circuit is
edited as part of the tunnel. For 4 Gbps platforms, the Delete, Enable, and Disable buttons do
not display. In addition, the Edit operation is only supported for cached circuits.
The 8 Gbps Extension Switch and 8 Gbps Extension Blade may have multiple circuits per
tunnel, and circuits may be selected individually.
The Edit FCIP Tunnel dialog box displays.
Editing FCIP circuits
"Configuring an FCIP
tunnel". You can edit all
20
663