Changing The Threshold Boundary Level - Brocade Communications Systems 8 Administrator's Manual

A
Port threshold configuration using the fwConfigure command

Changing the threshold boundary level

NOTE
The allowed advanced settings are displayed on a per-class basis. Although port fencing is displayed
for other areas, such as RX Performance, for which port fencing is not supported, you will not be able
to set or apply the changes on such areas.
1. Enter 4 at the Select choice => prompt.
106
The system generates output, which varies based on the class and area you select. In the
example shown here, the output is based on the E_Port class and RXPerformance area.
Index ThresholdName
216 eportRXPerf216
217 eportRXPerf217
218 eportRXPerf218
219 eportRXPerf219
220 eportRXPerf220
221 eportRXPerf221
222 eportRXPerf222
223 eportRXPerf223
Threshold boundary level is setat : Default
DefaultCustom
Unit Percentage(%)
Time base minuteminute
Low 0
High 100
BufSize 0
Threshold alarmlevel is set at: Default
Errlog-1, SnmpTrap-2, PortLogLock-4
RapiTrap-8, EmailAlert-16, PortFencing-32
Valid alarm matrix is 63
DefaultCustom
Changed 0
Below 0
Above 0
InBetween 0
1 : change behavior type
2 : change behavior interval
3 : change threshold boundary level 13 : change belowalarm
4 : change custom unit
5 : change custom timebase
6 : change custom low
7 : change custom high
8 : change custom buffer
9 : apply threshold boundary changes
10 : cancel threshold boundary changes
Select choice => : (1..18) [18]7
BehaviorType BehaviorInt
Triggered 1
Triggered 1
Triggered 1
Triggered 1
Triggered 1
Triggered 1
Triggered 1
Triggered 1
Percentage(%)
0
100
0
0
0
0
0
11 : change threshold alarm level
12 : change changed alarm
14 : change abovealarm
15 : change inBetween alarm
16 : apply threshold alarm changes
17 : cancel threshold alarm changes
18 : return to previous page
Fabric Watch Administrator's Guide
53-1001770-01