8U/4U SuperBlade Network System Options User's Manual
3-3
Locating and Identifying Switches and Switch
Ports on a Blade Enclosure
Use this section to help you in locating and identifying the switch ports and switches on
a blade enclosure.
Locating and Identifying a Switch on a Blade Enclosure
When you are looking at the rear of the blade enclosure, you can identify the switch
associating with a CMM designation by using the information in
Table 3-2. Locating and Identifying a Switch in 820C Enclosure
Locating and Identifying a Switch Port on a Blade Enclosure
In general, a switch that is designated on the CMM as "Switch A1", has its ports
electrically routed to the first network interfaces of the blade servers, while the switch
designed as "Switch A2" has its ports electrically routed to the second network
interfaces of the blade servers. However, pass-through Ethernet modules have a
one-to-one relationship between their internal and external ports.
Managed switches have internal ports that are associated with the blade server slots
and network interfaces (NIC).
NOTE: Not all switches shown are supported on all blade enclosures. Please check the
SuperBlade matrix for the supported models.
Switch
Switch Location
a
Name
A1
Lower Right Slot
A2
Left Slot
a. As shown on the CMM.
3-8
Table
3-2.