Change 1; Change To The Revision 1.0X - Agilent Technologies 4294A Operating Manual

Change 1

The firmware before the revision 1.0x does not support the following function.
• Saving the internal data in the touchstone format.

Change to the revision 1.0x

Chapter 8 , "Analysis and Processing of Result," on page 211
Delete the following section
• "Saving a data array in touchstone format" on page 285
• "Using a file saved in touchstone format" on page 286
Table B-105 on page 421
Modify as follows.
Key operation: [Save]
Softkey
STATE ä
Selects storage of the configuration states and internal data array of the Agilent
4294A and displays Table B-106, "Filename entry (File Name) menu," on page
421.
DATA ä
Selects storage of the internal data array of the Agilent 4294A and displays Table
B-107, "Data save (Save Data) menu," on page 422.
GRAPHICS ä Selects storage of the displayed screen in TIFF format and displays Table B-106,
"Filename entry (File Name) menu," on page 421. It is stored in the colors
selected in Table B-99, "Copy configuration (Copy Setup) menu (1/2)," on page
417. The softkeys are also stored.
RE-SAVE FILE ä
Displays Table B-111, "File selection (Select File) menu," on page 424.
POWER ON CONFIG ä
Displays Table B-109, "Power-on configuration save (Save config?) menu," on
page 423.
FILE UTILITIES ä
Displays Table B-110, "File utility (File Utility) menu," on page 423.
STORE DEV [ ] ä Displays Table B-81, "Mass storage (Store Device) menu," on page 408. In [ ]
of the softkey label, the currently selected mass storage is displayed (flexible
disk drive: [FLOPPY], volatile memory disk: [MEMORY], or nonvolatile
memory disk (flash memory): [FLASH]).
A
Change to the revision 1.0x
Function
Manual Changes
GPIB command
SAVDSTA <string>
(N/A)
SAVDTIF <string>
RESAVD <string>
SAVPSTA
(N/A)
(N/A)
357