Create A File For Automatic Setting When Power Is On - Agilent Technologies 4294A Operating Manual

File Select menu serve as the file names and the directory name lists (first four items in
alphabetical order when there are four or more files or directories) read from the selected
storage device.
Step 6. When the file to be overwritten is not displayed as a softkey label, use the following
method to display the file as a softkey label:
• Use the softkey of the file select menu to scroll the file/directory list of thee softkey
label.
Function
Displays the previous page of the list.
Displays the next page of the list.
• To move the directory, press the softkey of the corresponding directory name.
Function
Goes to the directory to display the file and
directory names located at that position.
Goes to the next higher-order directory and
displays the file and directory name located at
that position.
NOTE The directory name displayed as the softkey label is followed by "\".
Step 7. Use the softkey to select the file to be overwritten and start overwriting.

Create a file for automatic setting when power is on

When power to the Agilent 4294A is turned on, the system is set to a state normally called
"power on default setting," which is one of the default settings.
If you save the setting (using the STATE save function) with the file name
"AUTOREC.STA" in the storage device (flash memory or floppy disk), then the file is
automatically read when power is turned on, and the previous setting is reproduced. The
power on default setting file (AUTOREC.STA) can be created by the following steps:
Step 1. Set the Agilent 4294A to the state that you want to have automatically set (power on
default setting) when the power is turned on.
Step 2. Press the
Step 3. Press the
menu.
Step 4. Press the
AUTOREC.STA file. To suspend saving, press the
menu returns.
NOTE If the
nonvolatile memory disk (flash memory), regardless of the selection state of the storage
Chapter 8
Save and Recall the Agilent 4294A Internal Data
key to display the Save menu.
[Save]
key to display the Power On Default Setting File Save
POWER ON CONFIG
key to save it into the non-volatile memory disk (flash memory) of the
yes
key is used, the AUTOREC.STA file is always stored in the
POWER ON CONFIG
Analysis and Processing of Result
Key operation
PREV FILES
NEXT FILES
Key operation
Directory name\
..\
key. In both cases, the Save
cancel
291