Checking The Mac Address - Agilent Technologies 4294A Operating Manual

Setting/Using Control and Management Functions
Setting/Checking the LAN
Step 10. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 4th part of the subnet mask.
•
•
•
The 4th part of the subnet mask can be set to an integer ranging from 0 through 255.
Step 11. Press the
4294A and to return to the Local menu.
NOTE When you want to cancel the setting of the subnet mask, press the
done
Step 12. Reboot the Agilent 4294A. This will put the entered subnet mask into effect.
When you set the LAN addresses (IP address, gateway address, and subnet mask) at one
time, you need to reboot only after the completion of all settings to put all of the LAN
addresses into effect.

Checking the MAC Address

Follow these steps to check the MAC address.
Step 1. Press the
Step 2. Press the
Step 3. Press the
area of the screen, the MAC address, delimited by colons, is displayed.
NOTE The MAC address is a unique address assigned to each instrument. You cannot change the
MAC address.
You can check the MAC address with the sticker above the LAN port on the Agilent
4294A's rear panel. For the location of the LAN port on the rear panel, refer to "4. LAN
Port" on page 51.
318
Enter the desired value with the numeric keys (
key.
Turn the rotary knob ( m m m m ) until the desired value is set.
Press the step keys ([­][¯]) to set the desired value.
key to store the IP address data set in Steps 3 through 10 in the Agilent
done
key. The previous subnet mask setting remains without changes.
key to display the System menu.
[System]
DIAGNOSTIC TEST
key. At the top of the set parameter value field in the upper left
MAC ADDRESS
to
[0]
key to display the Self-Diagnosis menu.
) and then press the
[9] [´1]
key instead of the
cancel
Chapter 9
unit