Selecting The List Sweep As The Sweep Type; Setting The Horizontal Axis Of The Graph For The List Sweep - Agilent Technologies 4294A Operating Manual

Setting Measurement Conditions
Sweeping Multiple Sweep Ranges with Different Conditions in a Single
Action (List Sweep)
previous segment are specified as initial values for the sweep start/stop frequencies (the
same logic is applied to initial values for a sweep range specified with sweep center/span
frequencies). Thus, a continuous sweep frequency range over the entire list sweep table
would be obtained if you specify the range by modifying only the sweep stop frequency for
each of the appended segments.
Step 31. When editing of the list sweep table is done, press the
Press the
NOTE When you quit editing of a list sweep table by pressing the
to its original state before the edit mode was entered.
Figure 5-19

Selecting the list sweep as the sweep type

You can execute the list sweep according to the completed list sweep table by selecting list
sweep as the sweep type. For how to select the sweep type, refer to "Selecting Linear, Log,
or List Sweep" on page 87.
Step 1. Press the
Step 2. Press the
Step 3. Press the

Setting the Horizontal Axis of the Graph for the List Sweep

There are two types of list span modes that can be selected for the horizontal axis of the
graph for the list sweep.
Step 1. Press the
Step 2. Press the
124
key to quit editing.
cancel
key to display the Sweep menu.
[Sweep]
key to display the Sweep Type menu.
TYPE [ ]
key to select the list sweep.
LIST
key to display the Sweep menu.
[Sweep]
key to select the setting for the horizontal axis for the list sweep
LIST SPAN [ ]
key in the list sweep menu.
done
key, the table will revert
cancel
Chapter 5