Agilent Technologies 4294A Operating Manual page 448

Error messages
NO STATE/DATA FILES ON MEMORY
softkey labels with the recall ([Recall]) key, file re-save (RE-SAVE FILE) key, file deletion
(PURGE FILE) key, directory change (CHANGE DIRECTORY) key, or file copy (COPY
FILE) key, no file or directory corresponding to the execution of the key is on the floppy
disk.
116 NO STATE/DATA FILES ON MEMORY
Although you attempt to display the list of files and directories on a volatile memory disk
or nonvolatile memory disk (flash memory) on the softkey labels with the recall ([Recall])
key, file re-save (RE-SAVE FILE) key, file deletion (PURGE FILE) key, directory change
(CHANGE DIRECTORY) key, file copy (COPY FILE) key, and so on, no file or directory
corresponding to the execution of the key is on the volatile memory disk or nonvolatile
memory disk (flash memory).
55 NOT ENOUGH DATA
When data is sent from the controller to the Agilent 4294A in the FORM2, FORM3, or
FORM5 data transfer format, the amount of sent binary data is too small, or data items do
not reach the number of points (NOP) set in the 4294A. Set the amount of data to be sent or
the number of points correctly.
83 NOT VALID FOR COMPLEX MEASUREMENT
When the COMPLEX Z-Y measurement parameter (that is, complex parameter
measurement) is selected, a command to execute one of the following is sent. As a result,
the command is ignored.
•
•
•
When making the above settings, first select a measurement parameter other than
COMPLEX Z-Y.
84 NOT VALID FOR SCALAR MEASUREMENT
When a measurement parameter other than COMPLEX Z-Y (that is, scalar parameter
measurement) is selected, a command to execute one of the following is sent. As a result,
the command is ignored.
•
•
When making the above settings, first select the COMPLEX Z-Y measurement parameter.
-120 Numeric data error
Numeric data (including numeric data without a decimal point) is causing an error. A
numeric value error other than -121 to -129 has occurred.
-128 Numeric data not allowed
A numeric value data element (that did not violate the standard) is received where the
Agilent 4294A does not accept any numeric value data elements.
440
Setting or reading an offset value in the trace calculation function (DATOVAL
command)
Assigning the main marker to the offset value in the trace calculation function
(MKROFS command)
Selecting DELTA % in the trace calculation function (DISP DELP command)
Setting the secondary measurement parameter value of the fixed D marker
(DMKRAUV command)
Selecting DATA/MEM in the trace calculation function (DISP DDVM command)
Appendix C