Agilent Technologies 4294A Operating Manual page 395

Table B-51 DC bias mode (DC Bias Mode) menu
Key operation: [Sweep] - EDIT LIST - EDIT - more 1/3 - BIAS MODE [ ]
[Sweep] - EDIT LIST - ADD - more 1/3 - BIAS MODE [ ]
[Source] - more 1/2 - MODE [ ]
Softkey
VOLT Selects the voltage source as the dc bias source configuration.
|
CURRENT Selects the current source as the dc bias source configuration.
|
VOLT CONSTANT Sets the constant voltage source as the dc bias source configuration. The output
| voltage is kept constant irrespective of the connected load. Note that the
maximum current is restricted.
CURRENT CONSTANT Sets the constant current source as the dc bias source configuration. The output
current is kept constant irrespective of the connected load. Note that the
maximum voltage is restricted.
return Returns to the higher-level menu (Table B-49, "Segment edit (Edit Segment)
menu (2/3)," on page 385 or Table B-54, "DC bias (Source Bias) menu," on
page 388).
Table B-52 List deletion (Clear List?) menu
Key operation: [Sweep] - EDIT LIST - CLEAR LIST
Softkey
yes Deletes all contents of the currently edited list sweep table from the screen and
returns to Table B-47, "List sweep (List Sweep) menu," on page 384. However,
even after all of the contents of the list sweep table have been deleted from the
screen with this key, you can reset the previously stored list sweep table by
pressing the cancel key in Table B-47, "List sweep (List Sweep) menu," on page
384 without deleting its contents.
cancel Cancels the deletion of the list sweep table from the screen and returns to Table
B-47, "List sweep (List Sweep) menu," on page 384.
Appendix B
Softkeys displayed by pressing the [Sweep] key
Function
Function
Key Definitions
GPIB command
DCMOD VOLT
DCMOD CURR
DCMOD CVOLT
DCMOD CCURR
(N/A)
GPIB command
(N/A)
(N/A)
387