Setting Number Of Points (Nop) - Agilent Technologies 4294A Operating Manual

Setting Number of Points (NOP)

Step 1. Press
Step 2. Press the
points in the parameter settings area in the upper-left part of the screen.
Step 3. Use keys or the rotary knob in the ENTRY block in one of the following ways to specify a
value for the number of points.
• Enter the desired value with the numeric keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
NOTE The number of sweep points can be set to any integer from 2 to 801.
When list is selected as a sweep type (list sweep), use a list sweep table to set the number
of points.
Setting the number of points is applied commonly to traces A and B.
Figure 5-12 Number of points: 51
Chapter 5
to display the sweep menu.
[Sweep]
key. This will display the current setting for number of
NUMBER OF POINTS
m m m m ) until the desired value is set.
Setting Measurement Conditions
Setting Number of Points (NOP)
to ) and then press the
[0] [9] [´1]
key.
97