Setting The Built-In Speaker (Beep Sound); Turning On/Off The Completion Beep; Turning On/Off The Warning Beep - Agilent Technologies 4294A Operating Manual

Setting/Using Control and Management Functions

Setting the Built-in Speaker (Beep Sound)

Setting the Built-in Speaker (Beep Sound)
The Agilent 4294A has a built-in speaker to output beep sounds. The beep sound functions
are classified into the following three groups. You can set each of them on or off.
Table 9-1 Beep functions of the Agilent 4294A
Type
Completion beep
Warning beep
Limit line test fail beep
Follow the steps below to turn on/off the completion beep and warning beep. For how to
turn on/off the limit line test fail beep, refer to Step 4 in "Conduct the limit line test" on
page 262.

Turning On/Off the Completion Beep

Follow these steps to turn on and off the completion beep.
Step 1. Press the
Step 2. Press the
Step 3. Press the
completion beep (pressing the key toggles your selection).
Softkey label
BEEP DONE ON off
BEEP DONE on OFF

Turning On/Off the Warning Beep

Follow these steps to turn on and off the warning beep.
Step 1. Press the
Step 2. Press the
Step 3. Press the
beep (pressing the key toggles your selection).
Softkey label
BEEP WARN ON off
BEEP WARN on OFF
304
key to display the System menu.
[System]
key to display the Built-In Speaker menu.
BEEPER
key (
BEEP DONE on OFF
key to display the System menu.
[System]
key to display the Built-In Speaker menu.
BEEPER
key (
BEEP WARN on OFF
Function
Sounds when storage of calibration or instrument states
is completed.
Sounds when a warning message occurs.
Sounds when the result of a limit line test is fail.
key) to turn on/off the
BEEP DONE ON off
Setting of the completion beep
On
Off
key) to turn on/off the warning
BEEP WARN ON off
Setting of the warning beep
On
Off
Chapter 9