Agilent Technologies 4294A Operating Manual page 242

Analysis and Processing of Result
Define the Peak
"Search the maximum/minimum peak" on page 228. It should be noted, however, that a
definition must be set in advance by using the
to ensure that the target peak is searched. To ensure that all peaks are detected, perform
peak search after setting the peak
Step 3. Press the
Step 4. Press the
Step 5. Press the
Step 6. Press the
position into the peak definition of
NOTE When using the
(where the sweep parameter value is smaller) of the peak at the main marker position is
used to define DX and DY.
With both the D marker and the main marker displayed on the screen, if you press the
® PEK DELTA
main marker and the D marker is assigned to the definition of DX; correspondingly, the
measurement parameter value (absolute value) of this difference is assigned to the
definition of DY.
234
Y value to zero using the
D
key to display the Search menu.
[Search]
key to display the Peak menu.
PEAK
key to display the Peak Definition menu.
PEAK DEF MENU
key to enter the peak sharpness at the main marker
MKR ® PEAK DELTA
D
MKR ® PEK DELTA
, the sweep parameter value (absolute value) of the difference between the
key and
PEAK DEF DX
PEAK DEF DY
X and Y .
D
key to define the peak, the sharpness of the left side
key
PEAK DEF DY
.
MKR
Chapter 8